Custom Window banners
Now you can easily create a custom windshield banner for your ride. Give your ride a whole new look.

Banner is curved for a true professional OEM fit on the windshield.

Approx 39" long and 3" high.

Price $14.95 + $3.95 shipping

How To Install:

Notes:

Banner Text is slightly compressed vertically: the banner lettering is slightly compressed vertically for a more custom look and to ensure it fits properly on the windshield.

Banner Text is curved for front windshield glass: It might appear like a straight banner above, but in order for it to fit properly on your curved front windshield, your banner is curved by default. If you chose "no" during ordering, then your banner will be straight for placement anywhere (like your rear window or side of your car, etc).

Onto the install(s) there are 2 ways you can install the banners, wet or dry:

THE WET METHOD

Trim down banner close to the letters. Careful not to cut your letters.

Spray the whole windshield down with window cleaner. Peel the banner from the backing sheet and spray it down also. We just used plain water here, but on a hot day, window cleaner can be used like windex.

Put the banner in place and keep the whole area wet (spray down as needed) as you slide the banner around to look straight. Once straight, squeeze out all air bubbles and smooth out the banner.

Allow 8 - 24 hours for your banner to dry (depending on weather). The colder it is, the longer you need to wait to dry. Then remove the transfer tape slowly and carefully.

THE DRY METHOD

Trim the banner close to the lettering. Save the trimmed material. Place the banner on the windshield and hold in place using some of the trimmed material. Step back and make sure it's centered.

Carefully peel the banner away from the backing material. Next cut ONLY the backing material away close to the center. Careful NOT to cut your banner.

Carefully press down starting from the center outward. Once one side is down, go to the other side of the car and carefully peel center backing off including the center tape and repeat the step shown above.

You can now simply peel off the transfer tape (slowly and carefully).

Note: The advantage of the "dry method" is you can install the banner in almost any weather (short of freezing weather) and be ready to go asap. The downside is that if you mess up using the dry method.. it's new banner time :-) If you don't have much experience with stickers, etc.. use the wet method above.